To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TC-SM 2531 U and is the answer not in the manual?
General| Input power | 1800 W |
|---|---|
| Power source | AC |
| Blade bore | 30 mm |
| Blade diameter | 254 mm |
| Idle speed (max) | 4800 RPM |
| Dust extraction | Yes |
Weight and Dimensions| Depth | 790 mm |
|---|---|
| Width | 460 mm |
| Height | 422 mm |
| Weight | 21200 g |
Specific safety guidelines and warnings pertaining to the laser module.
Detailed identification of all parts and components of the saw as shown in figures.
Details on sound pressure/power levels and vibration emission values according to standards.
Lists potential hazards and risks associated with the equipment's construction and layout.
General advice and requirements for setting up and preparing the equipment before use.
Detailed steps for performing a straight crosscut at 90 degrees with the turntable set to 0 degrees.
Instructions for making crosscuts at angles from 0° to 45° left and right on the turntable.
Guidance for performing miter cuts at angles from 0° to 45° relative to the work face.
Steps for executing double miter cuts involving both head and turntable angle adjustments.
Instructions for cleaning the equipment, including safety precautions and recommended methods.
Guidance on checking and replacing carbon brushes, emphasizing qualified personnel.
States that there are no internal parts requiring additional maintenance.
Information required when ordering spare parts and accessories.
