EINHELL TC-SY 18/60 Li User Manual (English)

Other manuals for EINHELL TC-SY 18/60 Li

Questions and Answers:

K
Kaitlyn CookeAug 6, 2025
Why is no material exiting from the EINHELL TC-SY 18/60 Li nozzle?
- A
  Alyssa JacobsAug 7, 2025
  Several issues can cause this. The nozzle or material tube might be clogged and require cleaning. The max paint volume control may be rotated too far anti-clockwise; try turning it clockwise. The material tube could be loose, so ensure it's properly inserted. Check if there's no pressure build-up in the container, and if not, tighten the container. Lastly, the material's consistency might be too thick, requiring dilution.
A
andrewsandersAug 11, 2025
Why is atomization too coarse with my EINHELL TC-SY 18/60 Li?
- A
  Alexander MillerAug 11, 2025
  This can occur if the material viscosity or volume is too high; dilute the material or turn the max. paint volume control anti-clockwise. A dirty nozzle, which requires cleaning, or insufficient pressure build-up in the container can also cause coarse atomization. In the last case try to tighten the container.
L
Laurie CruzAug 15, 2025
What to do if material drips from the nozzle of my EINHELL TC-SY 18/60 Li Paint Sprayer after spraying?
- T
  Timothy LopezAug 15, 2025
  If material drips from the nozzle after spraying, the nozzle may be loose and needs tightening. Alternatively, the nozzle or nozzle seal might be worn and require replacement. Also, check for solids in the air cap or nozzle and clean them.
J
Jared HoffmanAug 19, 2025
Why is there excessive spray mist when using my EINHELL TC-SY 18/60 Li Paint Sprayer?
- K
  Kimberly MoralesAug 19, 2025
  Excessive spray mist can occur if the gun is too far from the object; hold it closer. Additionally, try turning the max. paint volume control anti-clockwise.
J
Jean PadillaAug 23, 2025
What to do if the paint runs when using my EINHELL Paint Sprayer?
- A
  Allison ParkerAug 23, 2025
  If the paint runs, it means you applied too much material. Turn the max. paint volume control anti-clockwise to reduce the material flow.
R
russellmeganAug 28, 2025
Why does my EINHELL Paint Sprayer have an intermittent spray?
- P
  perezkevinAug 28, 2025
  An intermittent or fluttering spray usually means that almost all of the material in the container has been used up. Add more material to resolve this.
E
Edward NelsonSep 1, 2025
Why is the coating pattern too light and uneven with my EINHELL TC-SY 18/60 Li Paint Sprayer?
- G
  Glenn VargasSep 1, 2025
  If the coating pattern is too light and uneven, it may be because you are moving the paint spray gun too fast across the surface. Try moving the gun more slowly.