To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TC-TC 800 and is the answer not in the manual?
General| Bore size | - mm |
|---|---|
| Idle speed | 2950 RPM |
| Cord storage | Yes |
| Maximum power | 800 W |
| Blade diameter | 180 mm |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Cutting height @ 45° | 14 mm |
| Cutting height @ 90° | 34 mm |
| Cutting disc swivel angle | 45 ° |
| International Protection (IP) code | IPX4 |
| Continuous operating time @ maximum power | 10 min |
Weight and Dimensions| Depth | 445 mm |
|---|---|
| Width | 440 mm |
| Height | 215 mm |
| Weight | 9100 g |
| Package weight | 10500 g |
Lists the numbered parts of the tile cutting machine.
Details the items included in the package and how to check them.
Instructions on assembling the equipment using figures.
Steps for replacing the diamond cutting wheel.
Guide on how to adjust the wheel guard.
Instructions for filling the water tank.
Procedures for performing straight cuts on the tile.
Steps for making angled cuts at 45 degrees.
How to operate the power switch of the machine.
Guidelines for cleaning the equipment.
Information regarding the maintenance of the machine.
Details on how to order spare parts for the machine.
