To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TE-TC 620 U and is the answer not in the manual?
General| Bore size | - mm |
|---|---|
| Idle speed | 3000 RPM |
| Diamond disc | Yes |
| Maximum power | 900 W |
| Blade diameter | 200 mm |
| Cutting length | 620 mm |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Cutting height @ 45° | 25 mm |
| Cutting height @ 90° | 30 mm |
| Cutting disc swivel angle | 45 ° |
| Continuous operating time @ maximum power | 30 min |
Weight and Dimensions| Depth | 1013 mm |
|---|---|
| Width | 455 mm |
| Height | 460 mm |
| Weight | 34400 g |
| Table depth | 325 mm |
| Table width | 610 mm |
| Package weight | 38600 g |
Follow all safety regulations and instructions to prevent electric shock, fire, or serious injury.
Follow specific instructions for safe setup, operation, and maintenance of the equipment.
Use the machine only for standard cutting of small/medium tiles, not wood or metal.
Instructions for switching the machine on and off using the ON/OFF switch.
Steps for setting the angle stop to 0° and performing 90° cuts.
How to set the angle stop to 45° and perform diagonal cuts.
Instructions for tilting the guide rail for lengthwise cuts at 45°.
Detailed steps for safely removing and installing the diamond cutting wheel.
