EINHELL TC-TC 800 User Manual

GB
- 20 -
Service information
We have competent service partners in all countries named on the guarantee certifi cate whose contact
details can also be found on the guarantee certifi cate. These partners will help you with all service re-
quests such as repairs, spare and wearing part orders or the purchase of consumables.
Please note that the following parts of this product are subject to normal or natural wear and that the
following parts are therefore also required for use as consumables.
Category Example
Wear parts*
Consumables* Cutting wheel
Missing parts
* Not necessarily included in the scope of delivery!
In the eff ect of defects or faults, please register the problem on the internet at www.isc-gmbh.info. Ple-
ase ensure that you provide a precise description of the problem and answer the following questions in
all cases:
•
Did the equipment work at all or was it defective from the beginning?
•
Did you notice anything (symptom or defect) prior to the failure?
•
What malfunction does the equipment have in your opinion (main symptom)?
Describe this malfunction.
Anl_TC_TC_800_SPK9.indb 20Anl_TC_TC_800_SPK9.indb 20 14.08.2017 09:42:2314.08.2017 09:42:23

EINHELL TC-TC 800 Specifications

General

Bore size	- mm
Idle speed	2950 RPM
Cord storage	Yes
Maximum power	800 W
Blade diameter	180 mm
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Cutting height @ 45°	14 mm
Cutting height @ 90°	34 mm
Cutting disc swivel angle	45 °
International Protection (IP) code	IPX4
Continuous operating time @ maximum power	10 min

Weight and Dimensions

Depth	445 mm
Width	440 mm
Height	215 mm
Weight	9100 g
Package weight	10500 g