To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TH-CS 1200/1 and is the answer not in the manual?
General| Output power | 1230 W |
|---|---|
| Power source | AC |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Blade diameter | 160 mm |
| Idle speed (max) | 5000 RPM |
| Cutting depth (45º) | 37 mm |
| Cutting depth (90º) | 55 mm |
| Saw blade included | Yes |
| Diamond disc | - |
Weight and Dimensions| Depth | 248 mm |
|---|---|
| Width | 257 mm |
| Height | 348 mm |
| Weight | 3700 g |
Use ear-muffs, breathing mask, and safety goggles to prevent injury.
Read and follow all safety regulations and instructions for future use.
Details components, figures, and items supplied with the circular saw.
Provides technical data, noise, and vibration levels measured according to EN 60745.
Check mains, disconnect power, adjust cutting depth and miter angle.
Connect vacuum cleaner for dust extraction, protecting health and work area.
Use parallel stop to saw parallel lines; adjust spacing and tighten screw.
Follow steps to safely remove and install saw blades using the wrench and securing screw.
Keep devices, vents and motor clean. Wipe with damp cloth or blow with compressed air.
Provide type, article number, ID number, and spare part number when ordering.
Dispose of equipment and packaging responsibly according to local regulations, not household refuse.
Store equipment in a dark, dry place above freezing temperature (5-30°C).
