EINHELL TH-MS 2112 - User Manual

TH-MS 2112
Art.-Nr.: 43.002.95 I.-Nr.: 11012
1
D Originalbetriebsanleitung
Kapp- und Gehrungssäge
GB Original operating instructions
Crosscut and miter saw
F Mode d’emploi d’origine
Scie à onglet
I Istruzioni per l’uso originali
Sega per troncature e tagli obliqui
S Original-bruksanvisning
Kap- och geringssåg
CZ Originální návod k obsluze
Kapovací pila
SK Originálny návod na obsluhu
Kapovacia píla
Anl_TH_MS_2112_SPK1.indb 1Anl_TH_MS_2112_SPK1.indb 1 06.03.14 11:0706.03.14 11:07

Summary

Safety regulations

Read all safety regulations and instructions.

Emphasizes the importance of reading and following all safety regulations and instructions to prevent electrical shock, fire, or injury.

Keep all safety regulations and instructions in a safe place for future use.

Advises storing safety regulations and instructions in a secure location for future reference and use.

Proper use

Proper use of the crosscut and miter saw.

Specifies the intended use of the saw for cutting wood and wood-type materials, and warns against misuse.

Residual risks

Technical data

Technical specifications of the saw.

Sound and vibration values.

Before starting the equipment

5.2 Setting up the saw (Fig. 3)

Provides instructions for setting up the saw, including inserting and tightening workpiece supports using a screwdriver.

5.3 Adjusting the saw (Fig. 1;2)

5.4 Precision adjustment of the stop rail (Fig. 7;8)

5.5 Precision adjustment of the stop for 90° cross-cuts (Fig. 8-10)

5.6 Precision adjustment of the stop for 45° mitre cuts (Fig. 8;12)

Operation

6.1 Crosscut 90° and turntable 0° (Fig. 1)

Describes how to perform a standard 90° crosscut with the turntable set at 0° using the saw.

6.2 90° cross-cuts and 0°-45° rotary table (Fig. 10)

Explains how to make 90° crosscuts with the rotary table set to angles between 0° and 45°.

6.3 Mitre cuts 0°-45° and rotary table 0° (Fig. 8;11)

Details how to perform mitre cuts from 0° to 45° with the rotary table fixed at 0°.

6.4 Mitre cuts 0°-45° and rotary table 0°-45° (Fig. 8;13)

Instructs on performing double mitre cuts with both the machine head and rotary table angled up to 45°.

6.6 Replacing the saw blade (Fig. 1-6)

Provides a step-by-step guide for safely replacing the saw blade, including necessary precautions.

Replacing the power cable

Procedure for replacing the power cable.

Cleaning, maintenance and ordering of spare parts

8.1 Cleaning

8.3 Maintenance

8.4 Ordering replacement parts

Service information

Information on service partners and fault reporting.

EINHELL TH-MS 2112 Specifications