Eircom 8010R - Resetting the Base; De-Registering a Handset

34
SETTINGS
Resetting the base
When you reset your base, all the base
parameters are reset to their initial values
(factory settings).
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET BASE. Press Valid. .
Select RESET BASE using  or . Press
Valid. .
A confirmation screen will prompt you to
confirm your request:
• To reset the base, press Yes .
• If you do not wish to reset the base,
press No .
Enter the base code. Press Valid. . The
RE-INIT. IN PROCESS message is
displayed on the screen.
To exit the menu, press the red key .
When resetting the base, the base
code becomes 0000 again.
De-registering a handset
This function enables you to de-register a
handset from your base. This may be
necessary if you have lost a handset or if you
already have 6 handsets registered to the
same base.
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET BASE. Press Valid. .
Select DELETE HANDSET using  or .
Press Valid. .
Select the handset you wish to unregister in
the list by pressing  or . Press
Valid. .
A screen prompts you to confirm the
unregistration. Press Yes to unregister
the handset.
To exit the menu, press the red key .
LU Eircom 8010R_D66.book Page 34 Vendredi, 28. novembre 2008 10:05 10