Eizo ColorEdge PROMINENCE CG3146 User Manual

Function Settings Description
SDI
Settings
Time Code
Settings
Time Code
Format
Position
Size
The time code can be set.
• Time Code
If this function is set to "On", the time code is displayed.
• Format
You can choose either "VITC" or "LTC" for the format of the time
code.
• Position
You can choose either "Top" or "Bottom" for the position to
display the time code.
• Size
You can choose either "Small" or "Large" for the size of the time
code.
Interlace / PsF Auto
Interlace
PsF
When an SDI signal other than progressive is input, the display
format can be set.
●
Color
The setting details di󰀨er depending on the color mode selected.
When the color mode is Standard Mode (BT.2020 / BT.709 / DCI-P3 / PQ_BT.2100 /
PQ_DCI-P3 / HLG_BT.2100 / SYNC_SIGNAL)
Each color mode setting can be adjusted according to personal preference.
Attention
• The same image may be seen in di󰀨erent colors on multiple monitors due to di󰀨erences between individual
monitors. Make ne color adjustment visually when matching colors on multiple monitors.
Note
• If "Color Mode" is "SYNC_SIGNAL", the "Brightness", "Gamma (EOTF)", and "Color Gamut" are automatically
set according to the input signal and cannot be changed.
• Use the values shown in "cd/m
2
" and "K" as a guide only.
19
Chapter 3 Advanced Adjustments/Settings

Eizo ColorEdge PROMINENCE CG3146 Specifications

General

Brand	Eizo
Model	ColorEdge PROMINENCE CG3146
Category	Monitor
Language	English