EK-Quantum Vector2 Strix RTX 3080 D-RGB - Step 2: Securing the Water Block with Screws

- 13 -
For this step, you will need:
Screws must be present in the places marked on the picture.
Phillips Head Screwdriver
STEP 2
Use five (5) M2.5x4 AX1 Screws and PVC washers to tighten the PCB
on the water block. Tighten the screws evenly using the Phillips-
head screwdriver. EK recommends you start tightening the
screws around the GPU core first, and then continuing outward to
prevent damage to the GPU.
Always use a plastic washer under each screw!
STEP 2
M2.5 x 4 AX1
SCREW
M2.5 PVC WASHER