EasyManuals Logo

EKO CORE 500 User Manual

EKO CORE 500
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
4
FCC Part 15.19(a)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Guidance Statement
In order to comply with FCC RF Exposure requirements, this device must be installed to provide adequate separation from the human body at all
times. Refer to section 2.6 Guidance and Manufacturer’s Declaration – Electromagnetic Emission.
Canada regulatory statement(s):
ISED Canada RSS-Gen Notice
IC: 23063-E8
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device
may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Guidance Statement
In order to comply with ISED RF Exposure requirements, this device must be installed to provide adequate separation from the human body at all
times. Refer to section 2.6 Guidance and Manufacturer’s Declaration – Electromagnetic Emission.
Afin de se conformer aux exigences d’exposition RF ISED, cet appareil doit être installé de manière à fournir une séparation adéquate du corps
humain à tout moment. Reportez-vous à la section 2.6 Guidance and Manufacturer’s Declaration – Electromagnetic Emission.
Japan MIC ID: PENDING CERTIFICATION
EU RED and United Kingdom EMC Compliance Europe
This equipment complies with the EMC requirements of the IEC 60601-1-2. See section 2.6 Guidance and Manufacturer’s Declaration –
Electromagnetic Emission.

Other manuals for EKO CORE 500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EKO CORE 500 and is the answer not in the manual?

EKO CORE 500 Specifications

General IconGeneral
TypeDigital Stethoscope
ConnectivityBluetooth
AmplificationUp to 40x
Active Noise CancellationYes
FDA ClearanceYes
HSA/FSA eligibilityYes
Water ResistanceIPX4
CompatibilityiOS and Android
Frequency Response20Hz - 2000Hz

Related product manuals