EKO MP-11 - Page 24

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 23
 Enter Pyranometer/Reference Cell constant value
 PV module/array parameter setting
14
Start measurement
8-5
15
In case of using the Sensor Unit with cable-less connection to the Main Unit:
Connect the Sensor Unit to MP-11 Main Unit and download the irradiance and
temperature measurement data from the Sensor Unit.
8-4
16
Display and analyze the measured data
8-5, 8-6
17
Disconnect the PV module/array from MP-11 while the power is still turned ON.
3-1, 3-2
18
Turn the MP-11 Main Unit power OFF.
8-2
19
Turn the Sensor Unit power OFF.
5-3
20
Disconnect the thermocouple cables from the Sensor Unit
5-3
21
Disconnect the Sensor Unit from MP-11 Main Unit.
5-3
22
Place the Angle Capturer back on the Sensor Unit.
5-3
23
Remove the grounding cable from MP-11 Main Unit.
5-3
24
Return the components, such as the Sensor Unit, thermocouple cables, and PV
probes back in their places.
5-3
25
Reconnect the power conditioner and other related devices which were
disconnected before taking measurement with MP-11.
3-1, 3-2