1) Measurement Date Setting
First set the measurement date to select the data to be displayed.
(1) By clicking the dropdown button located on the right side of the date box, a calendar appears.
(2) To change the years, click the Year title; the up/down buttons appears on the right. Click the
up/down buttons to change the year.
(3) To change the month, click the Month title. List of 12 months appears. Desired month can be
selected either from this dropdown list or by using the left/right arrows at both sides of the
Mont/Year title. As the Month title changes, the calendar also changes accordingly.
(4) Click the subjected date on the calendar.
(5) If necessary, setup the [ __Days] box by entering the number to show the data for the multiple days
from the selected measurement date.
(6) As the date setting is completed, the subjected data are displayed in the Data List box.
2) Graph Setting
Select a data which to be displayed on the graph from the Data List; while the selected data is
highlighted, click [View Graph] button to show the graph.
If the displayed graph scale is not appropriate, place a check on [Manual Graph Scale] checkbox and
enter the desired ranges for voltage and current; click the [View Graph] button again.
There are 7 characteristics which can be selected to show on a graph by placing check(s) on the item(s).
The color of each graph line can be selected from the pallet by clicking the [Line Color] button.
To Next Page
Loading...
