When the graph setting is completed, click [View Graph] button once again to show the graph.
3) Graph Superimposing Function
Up to 10 data can be displayed on a graph by superimposing mode for multiple data comparison.
Select measurement data from the data list by checking the checkboxes; also check the Superimpose
checkbox then click “View Graph” button to show the superimposed graph.
4) Data Upload/Erase
Data uploading is to transfer the measured data into the MP-11 Main Unit memory.
There are up to 300 measurement data can be saved by assigning the memory numbers from 001 to
300. The data uploaded from PC side can be also saved up to 120 measurement data, which are
assigned with numbers from 301 to 420.
To Next Page
Loading...
