SERVICE MANUAL
SM-eVENT-GB-3_8-2006.doc
4
• Prior the connecting the compressor, verify whether the mains voltage and frequency specified
on the apparatus are in accordance with the local supply.
• Prior to putting into operation, check for possible damages on the appliance and the air
connectors. Damaged cables and sockets/plugs must be replaced immediately.
• In the case of a dangerous situation or a technical failure, immediately disconnect the
appliance from mains supply.
• During all repairs and maintenance:
- ensure that the mains plug is removed from the power socket
- pressure pipes must be air vented
- pressure must be released from pressure tank.
• This appliance can only be installed only by a qualified expert.
1.5. Alert notices and symbols
For your information, the symbols below are used in the installation, operation and maintenance
manual, on packaging materials and on the product:
Information or instructions to prevent any injury to health or material damage
Alert against dangerous electric voltage
Special information regarding the correct use of the appliance and other warnings
CE – marking
Attention! Hot surface
Handling mark on packaging – Fragile, handle with care
Handling mark on packaging – This way up (Vertical position of freight)
Handling mark on packaging – Protect against humidity
Mark on packaging – Recyclable material
Handling mark on packaging – Temperature of storage and transport
Handling mark on packaging – Limited stacking
Connection of protective ground wire
Alternating current
Connector for equipotential connection
Fuse
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
