6 Donning and Doffing EVO
108842 A
CHAPTER 4: DONNING AND DOFFING EVO
Now that the EVO has been custom fit to the operator, it is time to put it on.
Donning EVO
1. Before putting on EVO, make sure to
unbuckle the hip belt, loosen the hip belt
webbing, and loosen the arm cuff straps.
2. Start by draping the EVO over your shoulders.
3. Secure the hip belt using the buckle. Position
the hip pads so they are covering your hip
bones, then tighten the belt by pulling on the
webbing loops inward. The belt should be tight
enough to avoid shifting, but not
uncomfortable.
4. Slip each arm through the arm cuff. Use the
pull handle strap to fully open the cuff to allow
for easier insertion.
5. Tighten the three straps on each arm from
bottom to top for a snug but comfortable fit.
Figure 6: Donning EVO Steps
To Next Page
Loading...
