ekwb EK-Loop Modulus Series User Manual

- 4 -
STEP 1:
First you need to put silicon insert inside your ACRYLIC/PETG tube.
You can use soap and a bit of water on silicon rod for easier installation.
STEP 1
BENDING TUBES
STEP 2:
Use industrial fan to heat up the ACRYLIC/PETG tube. You need to
rotate the tube while heating. You will notice that the tube is heated
enough when it starts to deflect under its own weight.
STEP 2
Industrial Fan
Silicon Insert
ACRYLIC/PETG
Tube

ekwb EK-Loop Modulus Series Specifications

General

Brand	ekwb
Model	EK-Loop Modulus Series
Category	Computer Hardware
Language	English