This product is intended for installation by expert users only. Please
consult with a qualified technician since improper installation
may result in damage to the equipment. EK assumes no liability
whatsoever, expressed or implied, for the use of these products,
nor their installation. The following instructions are subject to
change without notice. Please visit our website at www.ekwb.com
for updates.
Before you start using this product, please follow these basic guidelines:
Carefully read the manual before beginning with the
installation process.
EK Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured with the
rubber O-ring gaskets.
The use of quality market-proven corrosion-inhibiting
coolants is always strongly recommended for any liquid
cooling system.
Do not use pure distilled water as a cooling liquid! For best
results, EK recommends the use of EK-CryoFuel Coolants.
To Next Page
Loading...
Need help?
General
