Step 1 Placing the water tank / reservoir
1. Make sure the water tank / Reservoir is placed above the pump.
2. This enables water coolant to fill the pump and enables pump to fill the
whole system with water.
Step 2 Installation of connector
3. Setting the O-ring on the G1/4 threaded fittings.
4. Fitting the connectors with water outlet and inlet of pump tightly.
(The pump suits with G1/4 threaded fittings.)
Step 3 Installation of water tube
1. Setting the clamp on the tube first.
2. Tightly link the tube with connectors which connected with pump.
3. Using the clamp to clamp the junctions.
(Please make sure that every junction is tightly connected.)
4
To Next Page
Loading...
