ekwb EK-Vardar X3M 120ER - Replacing the Rubber Corners (Dampers); Step 1: Remove Existing Dampers; Step 2: Install New Dampers

- 5 -
REPLACING THE RUBBER CORNERS (DAMPERS)
STEP 1
First unscrew pre-installed M4 screws and thumb nuts using Allen
key (as shown on the photo). Carefully take off the rubber corner and
save the screws and nuts for later use.
STEP 1
STEP 2
STEP 2
New dampers need to be secured with M4 screws and Thumb nuts.
Don’t use excessive force while tightening the screws.
M4 Screw
M4 Thumb Nut