ELAC Miracord 60 - User Manual

Questions and Answers

B
Bryan RamirezAug 10, 2025
What to do if my ELAC Turntable motor doesn’t work?
- T
  Todd FergusonAug 10, 2025
  If the motor of your ELAC Turntable isn't working, there are several things you can check: * First, verify the turntable is properly connected to the mains and that the mains fuse is intact. Check the mains plug, receptacle, and fuse. * Next, ensure the power supply is correctly connected. Look at the low voltage plug and ensure it fits properly. * Finally, check that the front switch isn't in the '0' position. Switch it to the correct speed setting (33 or 45).
C
Carol SmithAug 15, 2025
Why is my ELAC Miracord 60 producing a loud humming noise?
- H
  hensleygregoryAug 15, 2025
  A loud humming noise from your ELAC Turntable may be due to the metal housing acting as an antenna, which creates AC Mains hum. To resolve this: * Check all connections. * For acoustical checks related to major problems, reduce the amplifier's volume level to minimum. * Readjust the RCA plugs ground rings.
M
Monica KingAug 20, 2025
What to do if the audio signals from my ELAC Turntable are not loud enough and sound distorted?
- N
  Natalie GutierrezAug 20, 2025
  If the audio signals from your ELAC Turntable are too quiet or distorted, it might be connected to the wrong input on your pre-amp. Make sure to connect the turntable to the phono input of your pre-amp, not the line input.
L
Lisa EspinozaAug 26, 2025
Why is the music pitch wrong on my ELAC Miracord 60 Turntable?
- K
  Karen CruzAug 26, 2025
  If the music pitch is incorrect on your ELAC Turntable, the wrong speed may be selected. Check the speed that should be used for the record you are playing. Some records with the same diameter as an LP (30 cm) must be played at 45 rpm, while some singles (17 cm) should be played at 33 ? rpm.
J
Jenny SmithAug 30, 2025
How to fix if the right channel appears on the left channel and vice versa on my ELAC Miracord 60?
- S
  Samuel DrakeAug 30, 2025
  If the right and left audio channels are swapped on your ELAC Turntable, the RCA plugs are likely connected to the wrong jacks. Swap the two RCA plugs (left and right channel) plugged into the turntable's RCA jacks.
T
thomascrawfordSep 4, 2025
How to reduce faint humming noise from my ELAC Turntable?
- T
  Tamara GarciaSep 4, 2025
  A faint humming noise from your ELAC Turntable could be due to an unattached ground wire. In certain cases, connect the metal parts of the turntable to the signal ground of the (phono-) preamp using the earthing screw on the rear side of the turntable and the wire attached to the included RCA cables.