Need help?Do you have a question about the ELAC Miracord 625 and is the answer not in the manual?
General| Drive System | Belt drive |
|---|---|
| Speeds | 33 1/3, 45 rpm |
| Tonearm | Static balanced tonearm |
| Platter | Aluminum die-cast |
| Wow and Flutter | 0.08% (WRMS) |
| Signal-to-Noise Ratio | >65dB |
Provides an overview of the instruction book and initial setup guidance for the record changer.
Securing the unit during transport and initial mounting steps.
Instructions for mounting the turntable and its counterbalance.
Guides on fitting the cartridge, connecting to amplifier and power.
Procedures for unlocking, balancing the tone arm, and setting tracking/anti-skating forces.
How to load records, select speed, start, and stop playback.
Details on changer, single-play, repeat, and manual operation modes.
Steps for mounting, aligning, and wiring the cartridge.
Adjusting stylus landing position and tone arm lift height.
Guidance on cleaning the unit's moving parts and idler wheel.
Instructions for cleaning and replacing the stylus.
Procedure for adjusting the tone arm brake mechanism.
Guidance on replacing the stepped pulley for speed selection.
Information on compatible ELAC cartridges and replacement styli.
Details on the SA 383 spindle and PV 11 equalizer-preamplifier.
Recommended bases and dust covers for table installation.
Instructions for preparing the mounting board and fixing the chassis.
To Next Page
