Why does the music from my ELAC Turntable not sound natural?
If the music on your ELAC Turntable doesn’t sound natural, verify that you've selected the correct speed for the record. Some records, like maxi singles, require 45 rpm, while some EPs should be played at 33 ? rpm, regardless of their size.
What to do if the ELAC MIRACORD 70 audio is distorted or not loud enough?
If you're experiencing distorted or quiet audio even with the volume maxed out on your amplifier, ensure that the preamplifier connected to the ELAC Turntable provides a suitable input and RIAA equalization. If needed, connect a phono preamp. For the Audio Technica AT95 system, set your phono preamp to 'Moving Magnet' with an input impedance of 47 kOhm.
Why is my ELAC Turntable motor not working?
If the motor of your ELAC Turntable isn't working, check the following: * Ensure the turntable is properly connected to the mains and that the mains fuse isn't burnt through; check the mains plug, receptacle, and fuse. * Verify the low voltage plug is correctly fitted and secure it if necessary. * Make sure the front switch is set to the “1” position, not “0”.
How to fix a loud humming noise from ELAC Turntable?
If you hear a loud humming noise from your ELAC Turntable, check all connections. For acoustical checks related to major problems, reduce the amplifier's volume to a minimum. It may be necessary to readjust the ground rings of the RCA plugs, as the metal housing might be acting as an antenna and picking up the humming.
What to do if the ELAC MIRACORD 70 channels are swapped?
If you're experiencing the right channel audio on the left channel and vice versa with your ELAC Turntable, swap the two RCA plugs (left and right channel) that are plugged into the turntable’s RCA jacks.
How to eliminate faint humming noise from my ELAC MIRACORD 70 Turntable?
To address a faint humming noise from your ELAC Turntable, connect the metal parts of the turntable to the signal ground of the (phono-) preamp. Use the earthing screw on the rear side of the turntable and a wire with sufficient cross-section for this ground connection. The metal housing might be acting as an antenna and picking up the humming.
To Next Page
General
