Elan EL-IPD-MTX-8CH Integration Note

1 of 11
ELAN
Integration
Note
Manufacturer: ELAN IPD Multi Chassis
Model Number(s):
EL-IPD-MTX-8CH
EL-IPD-PRE-MSI
EL-IPD-AMP-EXT
EL-IPD-PRE-SSI
EL
-
IPD
-
NAC
-
EXT (Dante Network Card)
Minimum Core Module Version: 8.5.2.0
Document Revision Date: 06/25/2020
OVERVIEW AND SUPPORTED FEATURES
The ELAN IP Amps are multizone, and multisource audio switchers that can be controlled by the ELAN
software using IP. Using Dante, the various chassis can communicate and share/stream sources over IP.
THE FOLLOWING FEATURES ARE SUPPORTED:
Source and Volume control: Each zone has independent control of the source selection and volume
control
Independent Zone Settings: Each zone has a prebuilt settings page with: Loudness, 5 band
customizable EQ, and Do Not Disturb (DND) settings
Configurable zone outputs: The outputs are independent from zones and can be assigned to any zone
for a very flexible installation. Using Dante, you can expand the number of chassis and therefore the
number of zones.
12 V Trigger outputs/Audio Sense Inputs: The EL-IPD-MTX-8CH, EL-IPD-PRE-MSI, and EL-IPD-AMP-
EXT all come with 3 12-volt trigger outputs, and also with the ability to detect audio inputs. These can be
used by configuring event maps.
Doorbell/Zone Paging: The EL-IPD-MTX-8CH and EL-IPD-PRE-MSI come with a dedicated doorbell
source that can be used with an ELAN SC100 or G1 to ring a doorbell or send a page through multiple
zones.
THE FOLLOWING FEATURES ARE NOT SUPPORTED:
Control from HC Controllers: Only SC2, SC 10, SC100, and G1 can be used for control.
.
Any feature not specifically noted as supported should be assumed to be unsupported.

Elan EL-IPD-MTX-8CH Specifications

General

Brand	Elan
Model	EL-IPD-MTX-8CH
Category	Amplifier
Language	English