Elba ELIO E93 MF - Page 45

45
ENAMELLED P AR TS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microbre or soft
cloth.
Acidic substances like lemon juice, tomato
sauce, vinegar etc. can damage the enamel
if left too long.
S TAINLES S S TEEL S UR F AC ES
( MO DELS W ITH O UT ANTI-
F ING ER P R INT TR EATMENT) ,
ALUMINIUM P AR TS AND P AINTED O R
S ILK - S C R EEN P R INTED S UR F AC ES
Clean using an appropriate product. Always
dry thoroughly.
IMP O R TANT: these parts must be cleaned
very carefully to avoid scratching and
abrasion.
You are advised to use a soft cloth and
neutral soap.
S TAINLES S S TEEL S UR F AC ES W ITH
ANTI- F ING ER P R INT TR EATMENT
( S O ME MO DELS O NLY)
C AUTIO N: The stainless steel front
surfaces used in some ovens are protected
with a Special Lacquer to reduce nger-
print marks.
To avoid damaging this lacquer, do not
clean the stainless steel with abrasive
cleaners or abrasive cloths or scouring
pads.
ONLY SOAP/WARM WATER MUST BE
US ED TO C LEAN TH E S TAINLES S
S TEEL S UR F AC ES .
G LAS S C O NTR O L P ANEL ( MO DELS
W ITH G LAS S C O NTR O L P ANEL)
Clean using an appropriate product.
Always dry thoroughly.
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the control
panel since they can scratch the surface,
which may result in shattering of the glass.
Do n o t u s e h a r s h a b r a s i v e c l e a n e r s o r s h a r p m e t a l s c r a p e r s t o c l e a n t h e o v e n d o o r
g l a s s s i n c e t h e y c a n s c r a t c h t h e s u r f a c e , w h i c h m a y r e s u l t i n s h a t t e r i n g o f t h e
g l a s s .