20
S
D
B
C
Fig. 7.1
ASSEMBLING THE BACKGUARD
Before assembling remove any protective film/adhesive tape.
1. Insert the side supports S and D into the backguard B (see fig. 7.1)
2. Insert the backguard group into the support guides in the cooker
3.
The backguard can be removed for cleaning or fixed with a screw through the hole C.
7 - CLEANING AND MAINTENANCE
IMPORTANT NOTES
Installation, and any demonstration, information or adjustments are not included in
the warranty.
The cooker must be installed by a qualified person in accordance with the Gas
Safety (Installation and Use) (Amendment) Regulations 1990 and the relevant
building/l.E.E Regulations.
Failure to install the appliance correctly could invalidate any manufacturers warranty
and lead to prosecution under the above quoted regulation.
In the UK C.O.R.G.I registered installers are authorised to undertake the installation
and service work in compliance with the above regulations. All Curry’s authorised
installers are C.O.R.G.I. registered.
Attention
The appliance gets very hot, mainly around the cooking areas. It is very
important that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance
thus making it unsafe.
To Next Page
Loading...
