50 / EN
User Menu
HP WATER HEATER
This menu is available only if a DHW heat pump is installed.
For further information, see the product manual.
– "Operation mode": sets the DHW production mode.
– "Quiet mode activation HPWH" refer to the paragraph
“Heat Pump”. For DHW heat pumps you can only activate
the function. You cannot set a start and end time.
Heat pump water heater
Operation mode
Comfort
Quiet mode activation HPWH OFF
Fig. 71
"Operation mode":
– "GREEN": the heating elements are excluded from the
production of domestic hot water and are activated only in
case of a heat pump malfunction.
– "Comfort": domestic hot water is produced using both
the heat pump and the heating elements.
– "Fast": domestic hot water is produced by using both the
heat pump and the heating elements at the same time.
The heating elements are switched on together with the
heat pump to minimise the DHW storage tank charge time.
– "I-memory": an algorithm optimises domestic hot water
production according to the user’s habits.
– "HC - HP": the production of domestic hot water follows
the settings of the EDF signal. To configure the EDF signal
of the heat pump, see the product manual.
PHOTOVOLTAIC INTEGRATION
This menu is available for products that are configured for
integration with a photovoltaic system (heating/cooling, hy-
brid, DHW heat pumps).
– "Photovoltaic integration": sets the use of the DHW
storage tank heating element for supported heat pumps
(see the product manual for further information).
– "None"
– “Photovoltaic integration”: activates the heating
element of the DHW storage tank (also simulta-
neously to heating or cooling) when additional
electrical energy is available from the photovoltaic
system.
– "PV offset DHW setpoint temperature": if a heating
heat pump or a hybrid system is installed, the parameter
sets the degrees to be added to the temperature set-point
for DHW storage tank charge when additional electrical en-
ergy is available from the photovoltaic system.
– "PV setpoint temperature": if a DHW heat pump is in-
stalled, the parameter sets the temperature set-point for
DHW storage tank charge when additional electrical ener-
gy is available from the photovoltaic system.
SYSTEM MEASUREMENT UNIT
This parameter sets the unit of measurement (international
system or USA system)
Advanced settings
Cooling settings
AUTO function
System measurement unit
Time Program mode
Room temperature correction
Zones selection
International system
USA system
Fig. 72
To Next Page
Loading...