To Next PageTo Next Page
Need help?Do you have a question about the elco TRIGON S PLUS and is the answer not in the manual?
Overview of the THISION S PLUS control unit's capabilities and functions.
Lists key functionalities like operating modes, target value settings, and control capabilities.
Covers weather-compensated control, cost-effective settings, and aeration for energy saving.
Discusses DHW temperature, circulation, and the importance of system maintenance.
Identifies and explains the physical buttons and display components of the control panel.
Details the step-by-step procedure for filling and de-aerating the heating system.
Explains the symbols and information shown on the control unit's display.
Introduces the programming capabilities available for end-users.
Adjusts room temperature and selects heating/water operating modes.
Covers displaying info, manual operation, de-aeration, and chimney sweep.
Explains the actions of specific buttons like ESC, OK, and Reset.
Navigates display and sets time/date and language for the operator.
Configures daily time schedules for heating circuits HC1, HC2, and HC3.
Configures daily time schedules for DHW preparation.
Sets up holiday modes and operating levels for heating circuits.
Adjusts room target values and characteristic heating curves.
Configures DHW setpoints and boiler manual operation target.
How to view system information and utilize manual operation mode.
Details the purpose and operation of the chimney sweep function.
Lists error codes and their descriptions for diagnosing system issues.
Lists maintenance codes and explains how to acknowledge reports.
Configure time, date, display units, and language for the control unit.
Set automatic timing programs for heating and domestic hot water.
Configure vacation mode settings for heating circuits.
Sets target temperatures for comfort, reduced, and frost protection.
Explains adjusting the heating curve for optimal performance.
Details setting nominal and reduced target temperatures for DHW.
Sets the target value for manual boiler operation.
Explains how to access and interpret error reports.
Describes acknowledging maintenance reports.
Details setting manual operation for specific functions.
Specifies electrical supply and connection details.
Covers software class, inputs, outputs, and interfaces.
Specifies protection classes and environmental operating conditions.
General