18
Manual operation
When the facility is operated in manual
mode, the relay output pins are no
longer switched according to the
standard control condition. Instead,
their function is set to a pre-dened
manual operation condition.
Target value settings for manual
operation
After the manual mode has been
activated, the system must be changed
over to default display. There the
symbol for maintenance/special
operations mode will be displayed .
By pushing on the information button,
the display changes to “Manual
operation”, in which the target value
can be set.
Line no. Operating line Factory setting
7140 Manual operation
OFF
Menu: Maintenance/special operating mode
To Next Page
Loading...
