ELCOS DCA-110 - Important Notices and Maintenance; General Warnings; Operating Environment Limits; Electromagnetic Compatibility

ELCOS- Parma- Italy - gb - DCA-110
7

127,&(6

Used only to check a diesel engine, while operating, commanding stopping if there are anomalies
in the parts controlled by the probes.
Designed to be installed inside dashboards, electric panels etc..

:DUQLQJ
$G KHUHFOR VHO\WRWKHIROORZLQJDGY LFH


- When making connections always follow the instructions and the Wiring Diagram on page 5.
- Any interventions on the unit must be performed with the engine stationary and terminal 50 of
the starting motor disconnected.
- Check that the consumption of the connected equipment are compatible with the described
technical characteristics.
- Install in such a way that there is always adequate heat disposal.
- Always install under other equipment which produces or spreads heat.
- Handle and connect without mechanically stressing the electronic card.
- Make sure that no copper conductor cuttings or other waste material fall inside the control unit.
- Never disconnect the terminals of the battery with running engine.
- Never use a battery charger for the emergency start-up; the control panel could be damaged.
- In order to safeguard people and equipment, before connecting an external battery charger,
disconnect the electrical system terminals from the battery poles.
7+,6 &21752/ 81,7 ,6 127 68,7$%/( )25 23(5$7,1* ,1 7+( )2//2:,1*
&21',7,216
:
- Where the environmental temperature is outside the limits indicated in the manual.
- Where the air pressure and temperature variations are so rapid as to produce exceptional
condensation.
- Where there are high levels of pollution caused by dust, smoke, vapour, salts and corrosive or
radioactive particles.
- Where there are high levels or heat from radiation caused by the sun, ovens or the like.
- Where attacks from mould or small animals are possible.
- Where there is the risk of fire or explosions.
- Where the control panel can receive strong vibrations or knocks.
- Where the control panel is protected by barriers or casing with protection level less than IP40.

(/(&7520$*1(7,&&203$7,%,/,7<
This control unit functions correctly only if inserted in plants which conform with the CE marking
standards; it meets the
exemption requirements of the standard EN61326-1 but it cannot be excluded that malfunctions
could occur in extreme
cases due to particular situations.
The installer has the task of checking that the disturbance levels are within the requirements of the
standards.
&21'8&7,21$1'0$,17(1$1&(
The following maintenance operations should be performed every week:
- check that the indicators function;
- check the batteries;
- check that the conductors are tight, check the condition of the terminals.
81/(66:(0$.($:5,77(1'(&/$5$7,2167$7,1*7+(&2175$5<7+,6&21752/
81,7,612768,7$%/()2586($6$&5,7,&$/&20321(17,1(48,30(17253/$176
5(63216,%/()25.((3,1*3(562162527+(5/,9,1*%(,1*6$/,9(


YOUR ELECTRICAL TECHNICIAN CAN ASK ANY QUESTIONS ABOUT
THIS CONTROL UNIT BY TELEPHONING OUR TECHNICIAN