9-33
HOW TO USE YOUR MOTORHOME’S EQUIPMENT
TELECO TV AERIAL
Connection to the Amplifier
Connect the lead exiting from the pole to the
ANT input of the amplifier. Connect with the
relevant lead, the TV connector of the
amplifier with the television. Connect the
amplifier to a 220V power socket or a battery,
making sure you do not invert the + and -
terminals (Fig 1).
OPERATING INSTRUCTIONS
1) Rotate the dB dial of the amplifier
clockwise.
2) Tune the television to a channel available
in the area where you are located.
3) Rotate and lift the antenna via the
suitable pole until you get the best image
on the TV.
Useful Tips
Not all the television signals you can receive
in the zone where you are located will
necessarily originate from the same direction.
So if the quality of a programme image is
poor, try rotating the antenna as the signal
may be coming from a direction different from
the others.
To Next Page
Loading...
