8. Commissioning
8.1 Preparation on receipt of the motorcycle in a shipping box
On receipt of the vehicle, the handlebar is disassembled.
It is therefore necessary to assemble all these components in order
to use the motorcycle.
Assembling the handlebars upon receipt
The handlebars are supplied in the box accompanying the
motorcycle and must be assembled in accordance with the following
procedure:
- Unscrew the 4 M8 screw of the upper handlebar holder
and remove them.
- Install the handlebar like the picture below.
- Install the again the handlebar holder and the 4 M8 screw
with a 6mm Allen key, tightening them at 20 Nm and taking
care of the position of the handlebar.
- Take care of the wires during mounting.
To Next Page
Loading...