- Disconnect the charger from the battery.
- Only on 25A charger, switch of the switch located on the
back side
- Unplug the charger from the wall plug.
Remarque : En cas de problème pendant la charge, veuillez répéter le
processus de chargement depuis le début pour remettre la batterie
en charge.
When the motorcycle is charging, do not turn on the
motorcycle using the ignition key, it would immediately stop the
charging process.
Regardless of the charger used, do not leave the battery
charging for too long, otherwise damage may occur.
If the battery has a failure, the charger’s LED n°2 will not be red but
green indicating that the battery is not charging. This may be due to
a damaged battery. It is therefore essential to contact a professional
certified by Electric Motion.
Take care to do not put any metal object inside the battery
charge plug on the battery.
Take care that the battery charge plug is not filled of water.
Do not leave the charger connected to the battery after
charge.
Pull back the metallic part of the connector, then
turn to left, then pull the connector
To Next Page
Loading...