Always shut off the unit and unplug from the mains before cleaning or performing any
maintenance. When it is not in use for long periods it is advisable to remove the plug
from the power socket. Do not use chemical solvents (such as benzene, alcohol or
gasoline) as they may cause irreversible damage to the unit.
1. CLEAN THE GRILLE AND CASE
Use water and a mild detergent to clean
the washable mesh filters. Do not use
bleach or abrasives. Do not splash water
directly onto the main unit. Doing so may
cause an electrical shock and can lead
to the insulation to deteriorate, or cause
the unit to rust. The air intake and outlet
grilles get soiled easily, so use a vacuum
attachment or soft brush to clean. Wipe the
dehumidier body with a soft damp cloth or
kitchen towel.
Remove the ABS lter frame. If the optional HEPA or carbon lters are tted, remove them
and hoover gently approximately every 2-3 weeks.
If the mesh lter is dirty hoover it, if it is heavily soiled wash it with warm soapy water and dry
thoroughly before reinserting it in the unit.
When lter cleaning is nished and lters are dry placed them back into the unit.
NOTE: While the carbon and HEPA lters are optional never run the unit without the mesh
lter frame correctly inserted.
2. CLEAN THE WATER TANK
Every few weeks, clean the tank to prevent growth of mould, mildew and bacteria. Partially ll
the tank with clean water and add a little mild detergent. Swish it around and then empty the
tank and rinse.
NOTE: Do not use a dishwasher to clean the tank. After cleaning and drying, the tank must
be reinserted securely into the dehumidier to restart operation.
END OF SEASON MAINTENANCE
1. Empty and clean the water tank.
2. Clean the unit and the lters as per cleaning procedure above.
3. Coil the power cord on the special cord storage rest at the back of the unit
4. Cover the unit and keep it in a dry place.
CARE AND MAINTENANCE
1413
To Next Page
Loading...
Need help?
General
