EasyManuals Logo
Home>ElectrIQ>Dehumidifier>CD12P

ElectrIQ CD12P User Manual

ElectrIQ CD12P
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Power Button: Press to turn the dehumidier on and off.
Timer: Press the timer button, then use the buttons to adjust the
duration of the timer (1-24 hrs, start/ stop timer).
If set while the unit is running: The number will represent the number of hours the unit will
operate before turning off. This will not be affected if the unit enters defrost mode or the tank
is emptied and reinserted.
If set while the unit is in standby: the set number represents the period in hours after which
the unit will start. To cancel start / stop mode press the timer key again.
Up and Down Buttons: During the High or Low modes when the unit is
displaying the current relative humidity, these buttons can be used to adjust
the desired humidity level. The desired relative humidity can be set between
35 and 80% in 5% increments.
SMART Mode: This is designed for maximum convenience and aims
to reduce the relative humidity to the level set and maintain the room at
that level. The default level is 55%, although this can be easily changed
using the UP and DOWN buttons.
During operation the compressor will operate until the desired humidity is reached and then
will stop. The air purier moves the air around the room ensuring all the air in the room is
processed and the humidity is correctly measured.
To allow more moisture in the air, press the up button and set to a higher desired humidity
(e.g. 60-70%).
We recommend setting the humidity to 50-55%. This is great for domestic operation and
dry storage
Setting the humidity to 60% is great for personal comfort and applications where 50% RH
is considered too dry
Setting the humidity to 70% is ideal for unoccupied properties or where an economical
run is needed without the need to reduce the humidity further.
LAUNDRY MODE: When drying clothes it is advised for the dehumidifier to operate
continuously with maximum water extraction until the water tank is full. Set the unit to the
Smart mode, and set the desired humidity level between 35%-50%. 35% is very dry and is
hardly achievable in a UK domestic environment. As such the unit will work until the water
tank is full when set to 35%.
NOTES:
POWER
TIMER
QUICK REFERENCE GUIDE
AIR PURIFIER
Do not place clothes directly over any of the vents on the dehumidier.
Make sure that there is nothing blocking the hot air exhaust air ow and for best results
place the laundry within 1.5 meters of the dehumidier.
If a permanent drainage pipe is tted the unit will not stop operating. Setting the desired
humidity to around 35% is good for laundry mode, a quick drying boost, or in emergencies.
It is not recommended for long normal operation in a domestic or ofce environment.
10
09

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ElectrIQ CD12P and is the answer not in the manual?

ElectrIQ CD12P Specifications

General IconGeneral
BrandElectrIQ
ModelCD12P
CategoryDehumidifier
LanguageEnglish

Related product manuals