ElectrIQ CD12P User Manual

CONTROL PANEL
POWER
POWER Button
Turn the appliance on/off
MODE Button
Select the function of the unit between SMART and FAN modes.
The LED’s next to the button will show which mode is selected.
SMART MODE: The unit will default to SMART mode the rst time
it is switched on and remains in this mode until another program is
chosen.
Air Purifier : The unit will run in fan mode and will not extract
water. Use with the HEPA or Active Carbon filter to improve air
quality or remove odour vic.
HUMIDITY SETTING
In SMART mode press the UP and DOWN buttons to select the
desired relative humidity level. The default desired humidity is
55%. When a relative humidity of 35% is selected, the compressor
will not stop until the water tank is full.
HUMIDITY
INDICATOR
LIGHT
HUMIDITY INDICATOR MODE
When the appliance is started, the indicator light will turn on
automatically. The indicator light colour will change according to
the humidity condition
Red – High humidity, Relative Humidity ≥ 70%
Orange – Comfortable level, 70% > Relative Humidity ≥ 60%
Green – Air is dry, Relative Humidity < 60%
The ”Humidity Indicator light” button can be pressed to turn on/
off the indicator light. Note: It can take around 2 minutes after
the humidity has changed into a different colour bracket for the
indicator will change the colour e.g. if humidity drops to 55% may
take 2 minutes before the indicator changes to green
0807
On/Off
Water full indicator
Defrost indicator
HUMIDITY
INDICATOR
LIGHT
TIMER
SMART
AIR PURIFIER
OPERATION
TANK FULL
DEFROST
MODE
HUMIDITY
INDICATOR
LIGHT
TIMER
SMART
AIR PURIFIER
OPERATION
TANK FULL
DEFROST
MODE
Humidity Indicator Down Up Mode
Timer
Power

ElectrIQ CD12P Specifications

General

Brand	ElectrIQ
Model	CD12P
Category	Dehumidifier
Language	English