Page 10 of 14
WATER-DRAINAGE
1. Manual drainage:
1.1 When the internal water tank is full the unit will stop working and
display will show FL error
1.2 Shut off the unit and unplug. Try not to move the model abruptly
as this may cause water to spill out from internal water tank.
1.3 Place a tray under the water plug.
1.4 Screw off the water plug and unplug the water blocker - water will
drain from the container.
1.5 Put the water blocker back and screw the water plug back into
place
2. Continuous drainage:
2.1 Screw off the water plug and unplug the water blocker.
2.2 Use a water pipe to connect to the water outlet.
2.3 You can plumb this pipe into your current plumbing system, lead it outside or use a water
pump.
Note: This model has a self-evaporative function, which reduces the need to empty the water tank.
If the unit is vented correctly most of the water is reused to cool the condenser coils and any
excess is evaporated.
Please do not use continuous drainage if you intend to use the self-evaporating facility.
To Next Page
Loading...
