34
en | RE3-RX r eceiver
RE3 UHF
21.06 | 3 | F.01U.362.808 Installation manual Electro-
RFPower
Selects transmitter RF output power. This option is
band specific.
NOTE: 8M Band is not adjustable.
Lo or High
AutoOFF
Assigns a time period for the transmitter to
automatically turn off once mute is engaged to
conserve battery life.
minutes, and 30
minutes
KeyLock
Prevents unwanted tampering with, or changes to
transmitter parameter settings.
Off or On
Display
Selects the tuning information displayed on the
transmitter home screen.
Freq. or GP/CH
SYNC
Config
Allows selection of MicConfig items synced to the
transmitter during SYNC operation. Scroll with the ▼
and ▲ buttons. Select or deselect using SET.
Settings
Saves setting changes and exits to main menu.
Without
Save
Exits to the main menu without saving changes.
7.3.11 Adjusting receiver volume
Setting the receiver output gain through menu item 6, Volume sets the gain leaving the
receiver and arriving at the destination circuit; either a microphone preamp, or a line in
preamp.
1
Press the ▼ button to scroll down to Volume from the main
menu. Select by pressing SET to enter the Volume screen.
2
The display shows the current volume setting in dB of
attenuation where 0 dB is the highest output volume, and -50
is the lowest output volume before mute.
3
Use the ▲ and ▼ buttons to adjust to the desired volume.
Pressing ▲ increases the volume by 1 dB (press and hold the
▲ button quickly increases the value) and pressing
▼decreases the volume by 1 dB (press and hold ▼ button
quickly decreases the value).
To Next Page
Loading...
Need help?
General
