UHF Wireless RE3-RX receiver | en 27
-Voice Installation manual 2018-12 | 01 |
5 This returns to Current Group on the scan menu.
6
Either scroll ▼down to Exit and press SET, or briefly press SYNC
on the receiver front panel to return to the home screen. The
selected Group/Channel and associated Frequency displays on
the home screen.
OR
7.3.6 Return
Selecting Return in the Scan menu returns to the main menu.
1
While in the Scan menu, press the ▼ button to scroll down to
Return. Press SET.
2 The screen returns to the main menu.
3
Either scroll ▼down to Exit and press SET, or briefly press SYNC
on the receiver front panel to return to the home screen.
OR
4 Home screen
.
7.3.7 Manually setting frequency
Setting custom frequencies manually does not benefit from the scan function of locating clear
channels. It is important to note that manually entered custom frequencies may experience
interference, which can be avoided by using the scan function.
1
Press the ▼ button to scroll down to Frequency on the main
menu. Select by pressing SET to enter the Setup Frequency
screen.
2
The three digits to the left of the decimal are in millions (MHz) and
are highlighted. Pressing ▲ increases frequency in increments of
1 MHz per press, pressing ▼decreases frequency in increments
of 1 MHz per press. Press SET to move to next set of three digits.
To Next Page
Loading...
Need help?
General
