•
Up to 2 x 3500W Maximum
Continuous Output
• High Efficiency and Sonic Excellence
through Grounded-Bridge
Class-H Design
• Microprocessor Controlled
- Compound Thermal Protection
-
Auto Mains Input Voltage Select
-
Mains Circuit Breaker Supervision
• Front LCD-Panel for Operation Mode
Set-up and Monitoring
• Slot for Optional IRIS-Net™ Module
- Complete PC Control (CAN, Ethernet)
- State-of-the-art Real Time DSP (RCM26/28)
-
Unique System Diagnostics and Supervision
-
Compatible with all other IRIS-Net
Compatible Hardware
• Complete Protection Package
• Only 14.5 kg (32 lbs) for TG-7
• Designed and Manufactured
in Germany
Tour Grade amplifiers are designed for today’s most demand-
ing audio applications. They offer a unique combination of high output
power, sonic excellence, high efficiency, as well as state-of-the-art,
optional signal processing and system supervision via IRIS-Net software,
in a compact lightweight format.
Tour Grade amplifiers have a microprocessor controlled operation man-
agement system that provides useful features such as compound ther-
mal management (preventing amps from switching off in excessive ther
-
mal environment), automatic mains voltage detection and a circuit break-
er control that allows the TG-7 to operate on a 30A (120V) or 16A (230V)
circuit breaker with normal music signal.
Tour Grade amplifiers use a grounded bridge 3-step class-H topology to
ensure the highest acoustic performance and reliability
. The TG Series
also offers the power and transient response to drive subwoofers along
with the low distortion for critical HF signals. The high capacity switch-
mode power supply provides the headroom needed to ensure high
dynamic outputs and reliable operation on extreme low loads.
Optional IRIS-Net™ (Intelligent Remote & Integrated Supervision-
Network™) Modules available for the Tour Grade amplifiers open up a
whole world of state-of-the-art DSP
, remote control, networking and
unique system supervision – down to an individual loudspeaker compo-
nent. IRIS-Net™ software is an expandable, open architecture application
that operates under Windows™ and supports Ethernet, CobraNet™,
CAN-Bus, USB, and RS-232 interfaces.
There will be several modules available: RCM-26 (DSP
, AES/EBU input,
GPIO, CANBus), RCM-28 (DSP, GPIO, COBRA-Net™), RCM-20 (no DSP,
CAN-Bus) to allow any combination of central control and supervision
with central or decentralized signal processing. Connection to a PC run
-
ning IRIS-Net software can be achieved using a UCC-1 USB-CAN inter-
face and/or a N8000 digital matrix.
To Next Page
Need help?
General
