Electrolux 302 - Filling the Rinse Aid Dispenser; Adjusting the Rinse Aid Dispenser

18
1
2
3
4
e. Filling the Rinse Aid Dispenser
•Rinse Aid is a wetting agent which is essential for good drying performance.
It also helps stop streaks and spots showing on your dishware.
• The Rinse Aid Dispenser should always contain Rinse Aid, unless you are using
combination tablets. It will dispense a measured amount every time you
wash your dishes.
• The dispenser can hold enough rinse aid (125 ml) for many washes. The
level indicator will turn clear when you need to refill it.
•To fill the dispenser:
- unscrew the round cap anticlockwise, and
- fill it with a good quality rinse aid
• Do not overfill the dispenser
•Make sure that you close the cap firmly after you fill the dispenser.
f. Adjusting the Rinse Aid Dispenser
• If your local water is harder or softer than normal, you can change how much
rinse aid you use in the following ways: (See photographs below)
- Choose a higher number if there are drops of water or fog that looks like
chalk on the glassware.
- Choose a lower number if the glassware is smeared at the end of a program.