Electrolux 302 - Help Guide; Problem Solving

21
a. Helpful Hints
•We recommend that you buy kitchen equipment which is dishwasher safe.
•Using your dishwasher over a long time may discolour or fade some types of
dishes (e.g. ones with the pattern on top of the glaze) and aluminium saucepans.
• If you often wash lead crystal glass, they will become opaque (not clear).
• If you take more than one day to fill the dishwasher, rinse your dishes by using
the “Rinse” program at the end of the first day.
• Do not use steel wool, aerosol or solvent cleaners on any part of your dishwasher.
• Do not use lumpy or stale detergent. It will give you a poor wash.
• If you do not intend using your dishwasher for several weeks:
1. open the door a little
2. switch off the power
3. turn off the water supply.
b. Problem Solving
Please refer to your Warranty card for a full description of problems and Solutions
For the 302 and 403 models, if your dishwasher stops during a cycle, a fault condition
will be indicated on the display and the controller will “beep” every two seconds.
Once the fault has been rectified, press the ON/OFF button. The wash program
will continue.
FAULT BEEPER DISPLAY WHAT TO DO
Not filling Repeating single beep “
I 10
” Displayed Check water supply and tap.
Check inlet hose filter.
Not Draining Repeating double beep “
I20
” Displayed Check drain hose for kinks.
Check sink trap spigot for blockage.
Check filters and clean if dirty.
Overfill Repeating triple beep “
I30
” Displayed Turn off water tap and power.
Call service.
Electrical Fault Repeating 5 beeps “
I50
” Displayed Turn off water tap and power.
Call service.
Section E: Help Guide