Electrolux 5995502399 - Page 41

Electronic Control
3-19
Is Mold in Freeze
(left) position
and frozen solid?
Look for any obvious
obstruction to motion
of mold and remove.
Check T1 Status
Test (51C)
Check Heater Status
Test (54C)
Check Bail Arm
Test (51C)
Enter IM
Service Mode
Ask customer if there
have been any unusual
noises (clicking)
Switch
Remove motor, drop
mold to bottom center
(re-activate heater if
necessary to drop mold)
Check Fill Limit
mold to bottom center
(re-activate heater if
necessary to drop mold)
Remove motor, drop
mold to bottom center
(re-activate heater if
necessary to drop mold)
Flow Chart 8