2010 dmm 28/96 599 73 68-54
• LCD
The information described below is also displayed on the LCD:
• Padlock:
The icon lights up when the “child lock” is on.
To indicate that all the sensors are disabled to prevent children from
modifying, starting or pausing the cycle.
A sensor combination needs to be pressed to activate/deactivate it. It may
be silk-screen printed on the control panel or described in the instruction
manual.
• Door lock:
Lights up when the safety device stops door opening and switches off
when the door can be opened.
It flashes when the device is about to unlock the door (it is noticed with
PTC delaying devices, which need one or two minutes to open).
• Cycle time:
It lights up to indicate the cycle time
• Time left:
It lights up to indicate the time left until the end of the cycle.
• Weight sensor:
Group of icons representing the weight information of the laundry inside
the drum.
These represent the maximum load possible and the actual weight of the
laundry inside the drum, and suggest the quantity of detergent to pour into
the detergent dispenser.
See Chapt. 5.1.1.7 on page 29
• Delayed start
Selected on the related sensor. After the START/PAUSE sensor has
been touched, the countdown starts and the delay time decreases hour
by hour, from a delay of 2 hours up to 20 hours () 30’) 60’) 90’)
2h) 3h...) 20h) 0h).
During the last 2 hours, it decreases by 30 mins at a time.
Touch the sensor in sequence to increase the delay by 30’ up to
10 hours, whereas from 10 hours to 20 hours, the increase is of 1 (one)
hour every time the button is pressed.
During the programme selection phase, a delayed start can be
selected, from 30’ to 20 hours (30’
" 60’ " 90’ " 10h "11h…
"20h "0h) and the time is shown on the LCD display; during the last
one, the time decreases one minute at a time.
To cancel the delayed start time, after the cycle has started, pause the
washing machine using the related button and cancel the option.
• Wrong selection
The words “Not possible” are displayed in the text line.
To Next Page
