2010 dmm 70/96 599 73 68-54
Alarm Description Possible fault Machine status/action Reset
EF5
Unbalanced load Final spin phases skipped. ---------------- START/RESET
EF6
Reset If it continues, replace the main board. No action to be taken ----------------
EH1
Power supply frequency of
appliance outside the limits
Problem with the power supply network (incorrect/disturbed); Main
PCB faulty.
Wait for nominal
frequency conditions
ON/OFF
EH2
Supply voltage too high
Problem with the power supply network (incorrect/disturbed); Main
PCB faulty.
Wait for nominal
voltage conditions.
ON/OFF
EH3
Supply voltage too low
Problem with the power supply network (incorrect/disturbed); Main
PCB faulty.
Wait for nominal
voltage conditions.
ON/OFF
EH4
0Watt relay malfunction Main circuit board faulty. ----------------
ON/OFF
RESET
EHE
Inconsistency between FCV relay (in
the main board) and safety
“sensing” circuit
Faulty cabling; Main circuit board faulty
Safety drain cycle
Cycle stops with door open
RESET
EHF
Safety sensing circuit faulty (wrong
input voltage to microprocessor)
Main circuit board faulty
Safety drain cycle
Cycle stops with door open
RESET
To Next Page
