POINTS FOR ATTENTION WHEN OPERATING
1. During the course of operating, if you have turned off
the unit or changed operation mode from COOLING
MODE to FAN MODE, be sure to keep that state for
at least three minutes before switching to COOLING
MODE again.
2. Attaching the Air Filter
Before starting the air conditioner operation, make
sure that the air filter is well attached. If the unit has
not been used for a long time, it is recommended to
clean the air filter before your using the unit. For
continuous use, clean the air filter at least once every
two weeks.
3. Before turning on the unit, make sure that the air inlet
grille and air outlet grille are not obstructed by
anything.
5. If the unit is operated beyond the conditions specified above, it may cause a failure
of the unit.
4. This air conditioner is designed to be operated under conditions as follows:
Cooling Operation
Outdoor temp. : 18-43 C
Indoor temp. : 21-32 C
The relative humidity of room should be less
than 80%. If the unit is used in a condition with a
relative humidity over 80%, there will be condensed
water on the surface of the unit.
6. Relocation of the unit:
When changing the installation location of the air conditioner, consult the selling
agent from which you bought your unit.
Note:
NO!
THREE
MINUTES
3
To Next Page
Loading...
