EDW 7100
Q&CI Technical Support – RA
Chapter 3.1
Enable/disable Extra Rinse
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S1+S2 to enter this function.
L1 blinks indicating it is in Extra Rinse setting mode.
Salt icon shows the current setting of Extra Rinse. Salt icon off for disabled, on for enabled
2. Press button S1 to change the setting
3. Switching off the appliance by pressing On/Off button (S0) will exit Service mode.
Enable/disable Pulse Wash
After accessed Service mode (L1, L2 and L3 blinking):
1.
Press button S2+S3 to enter this function.
L2 blinks indicating it is in Pulse Wash setting mode.
Salt icon shows the current setting of Pulse Wash. Salt icon off for disabled, on for enabled
2. Press button S2 to change the setting
3. Switching off the appliance by pressing On/Off button (S0) will exit Service mode.
To Next Page
Loading...
