EDW 7300
Q&CI Technical Support – RA
Chapter 3.3
If a buzzer is equipped, it beeps for 5 seconds.
The alarm codes saved in memory are erased.
2. Switching off the appliance by pressing On/Off button (S0) will exit Service mode.
Functional Test Cycle
After accessed Service mode (L1, L2 and L3 blinking):
P
ress button S3 to start the test cycle. The cycle will not start if door is opened.
All LEDs under “MYTIME” are on for the duration of the test cycle.
Display shows the remaining time of test cycle.
The test cycle runs as a normal wash cycle. It can be cancelled or run to its end.
Enable/disable Extra Rinse
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S1+S2 to enter this function.
L1 blinks indicating it is in Extra Rinse setting mode.
To Next Page