43
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 955 101 116
String shelf 90 cm
PNC 955 101 069
String shelf 60 cm
PNC 955 101 067
Shelf support
PNC 942 120 051
Flex tube kit
When the hood is to be connected to an evacuation
channel use the flex tube kit containing one evacu-
ation flex tube, one roof connecting duct and two
"Tube clamps"
Order by the retailer.
Unpacking
Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 4).
Electrical connection
The hood has a power cord with moulded plug
with earth connection to be connected to a wall
outlet of 230 V.
The power cord length is 1 m.
Installation
Min
75 cm
Min
65 cm
Fig. 4
To Next Page
Loading...
