Electrolux EFI611W84W - Starting a Programme with the Delay Start; Cancelling the Delay Start after the Countdown Has Started; Changing the Delay Start after the Countdown Has Started; The Sensicare System Load Detection

If a selection is not possible an acoustic
signal sounds and the display shows
.
12.6 Starting a programme
1. Touch the Start/Pause button to start
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and stays
on.
2. The programme starts, the door is locked.
The display shows the icon to
indicate that it is still possible to stop the
cycle and add garments.
The drain pump can operate shortly
before the appliance fills water.
12.7 Starting a programme with the
delay start
1. Touch the Delay Start button repeatedly
until the display shows the desired delay
time.
2. Touch the Start/Pause button. The
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator .
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to pause
the appliance. The related indicator
flashes.
2. Touch the Delay Start button repeatedly
until the display shows
3. Touch the Start/Pause button again to
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause button to pause
the appliance. The related indicator
flashes.
2. Touch theDelay Start button repeatedly
until the display shows the desired delay
time.
3. Touch the Start/Pause button again to
start the new countdown.
12.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause button, the
SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
Time Manager is available, during this
phase the two dots separating hours from
minutes are blinking and the drum rotates
shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The SensiCare detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced.
22 ENGLISH